Jay’s GS Tool Kit

Jay Emirzian owner of Galaxy Dental Lab in South Carolina, put together this kit of “Green State” zirconia rotary instruments to reduce or even eliminate stain and glaze cycles after sintering! When he introduced the kit to us, we realized (as Jay did) this kit possesses transformative potential! We decided to partner with Jay to offer these tools. A video (below) presented by Jay teaches how he uses these tools and how you can get the most from them.

GS-A0

Carve primary and secondary anatomy into the occlusal table of posterior crowns. Extremely long life. - Metal Point (Carver) | [H] 54mm | [Ø] 5mm | RPM 20-25k

GS-C1

Take down the pins on crowns after being cut fro the puck. Use with truing stone to flatten out contours. Extremely long life. - Green Bullet (Med) | [H] 57mm | [Ø] 10mm | RPM8-20k

GS-C2

Contour the furcation’s of posterior crowns. Similar to GS-C1 but smaller for tight spaces. Use with truing stone for sharp tip. Extremely long life. - Green Point (Med) | [H] 47mm | [Ø] 6mm | RPM 8-20k

GS-PP

Prepolish entire crown. Perfect for contouring the occlusal table and turn down of the marginal offset to a knife edge. Medium to long life. - Wheel Red (Fine) | [H] 42mm | [Ø] 14mm | RPM 4-7k

GS-SF

Final polishing of green state zirconia. It gives a super-fine polish. Long life. - Wheel Yellow (Super Fine) | [H] 42mm | [Ø] 14mm | RPM 4-7k

GS-UF

Final Polishing (similar to the GS-SF) for ultra-fine polishing. Long life. - Wheel White (Ultra-Fine) | [H] 42mm | [Ø] 14mm | RPM 4-7k

GS-IP

Contour proximal areas of bridge connectors. Extremely long life. - Wheel Gray (Med) | [H] 41mm | [Ø] 15mm | RPM 4-7k

GS-TRU

Truing Stone for use with all burs (75mmx25mmx8mm)
Please Note: The life expectancy estimates are based on usage style, your results may differ.

Videos

MEET JAY

JAY’S PASSION *THE WHY*

TRAINING WITH JAY EMIRZIAN

BLOOPER REEL

Documentation (PDFs)